|
|
|
Donate | |||||||
| Anabolics Discussion FROM THIS POINT FORWARD, NO SOURCES MENTIONED IN THIS FORUM. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
05-09-2006, 11:46 AM
|
||||
|
||||
Got a problem with my Test guys??
Received from UG lab. Always has been good in the past. Went to fill my syringe last evening and it was separated. Seemed like the powder and oil was separated. There is large masses of wet powder bunched together in it.
Anybody ever experienced this? I emailed my guy and told him the problem. i hope he takes care of the issue. Anybody know what caused this? I'm thinking it wasn't sealed good and the air exposure messed it up. 13fingers 
__________________
"Being a fighter is like having a car. You can have the best car in the world, but if you don't have any gas in it, it won't get you anywhere!" Fujiwara "The more I sweat on the mat the less I bleed in combat" "Give me an inch and I'll take your foot" 13fingers@hush.com ADMIN@HCA SUPERMOD@SRM MOD@FT MOD@T-M VIP@VIP VET/IST@ABB VET@BBB VET@SM     
|
|
#2
05-09-2006, 12:56 PM
|
||||
|
||||
|
TBO ive never seen that problem before so maybe someone else here has.
Ive had test prop oil crash on me before but that was crystals at the top off the vial , all i did to fix that was place a 21g needle into the vial and heat the vial gentely in hot water till it all mixed again
__________________
|
|
#3
05-09-2006, 01:12 PM
|
||||
|
||||
|
Quote:
__________________
"Being a fighter is like having a car. You can have the best car in the world, but if you don't have any gas in it, it won't get you anywhere!" Fujiwara "The more I sweat on the mat the less I bleed in combat" "Give me an inch and I'll take your foot" 13fingers@hush.com ADMIN@HCA SUPERMOD@SRM MOD@FT MOD@T-M VIP@VIP VET/IST@ABB VET@BBB VET@SM
|
|
#4
05-09-2006, 01:21 PM
|
|||
|
|||
|
More than likely, as was said, it has fallen out of solution. I am sure your boy will take it back for a replacement. If he does not, then you may want to look for someone else. Good business says he will, bad business says he won't.
|
|
#5
05-09-2006, 02:53 PM
|
||||
|
||||
|
"Sorry about that. We tried to lower the amount of BA in product.
PLease send me order details again and shipping addy and we will resend right away. Thanks" good place.
__________________
"Being a fighter is like having a car. You can have the best car in the world, but if you don't have any gas in it, it won't get you anywhere!" Fujiwara "The more I sweat on the mat the less I bleed in combat" "Give me an inch and I'll take your foot" 13fingers@hush.com ADMIN@HCA SUPERMOD@SRM MOD@FT MOD@T-M VIP@VIP VET/IST@ABB VET@BBB VET@SM
|
|
#6
05-09-2006, 03:11 PM
|
||||
|
||||
|
Just pitch the old vial? Can I doing anything with it?
__________________
"Being a fighter is like having a car. You can have the best car in the world, but if you don't have any gas in it, it won't get you anywhere!" Fujiwara "The more I sweat on the mat the less I bleed in combat" "Give me an inch and I'll take your foot" 13fingers@hush.com ADMIN@HCA SUPERMOD@SRM MOD@FT MOD@T-M VIP@VIP VET/IST@ABB VET@BBB VET@SM
|
|
#7
05-09-2006, 04:14 PM
|
||||
|
||||
|
What compound is it and what concentration?
|
|
#8
05-09-2006, 04:22 PM
|
||||
|
||||
|
Testosterone Enanthate 250mg
20ml vial
__________________
"Being a fighter is like having a car. You can have the best car in the world, but if you don't have any gas in it, it won't get you anywhere!" Fujiwara "The more I sweat on the mat the less I bleed in combat" "Give me an inch and I'll take your foot" 13fingers@hush.com ADMIN@HCA SUPERMOD@SRM MOD@FT MOD@T-M VIP@VIP VET/IST@ABB VET@BBB VET@SM
|
|
#9
05-09-2006, 06:21 PM
|
||||
|
||||
|
Try heating it in an oven at about 250 degrees, make sure you have a pin in it for a vent. Wait until it's good and hot, swirl it around to mix BUT make sure ALL crystals have disolved, you'll both clog up your pin and it'll crash again.
|
|
#10
05-09-2006, 09:45 PM
|
||||
|
||||
|
Good business there with your guy stepping up.
As far as the stuff you have...sit it in a pan of water hot but not boiling, allow the water to go just to the neck of the vial, be sure to have a pin in the stopper to let off pressure. Let it warm good swirl the vial..not shake SWIRL.....sit it back in the water get it hot again, swirl again, I would bet you my lunch money that it will go back into solution and stay there if not then send it to me...lol
__________________
I KNOW NOTHING!
|
 |
 |
Linear Mode
