Thing white material in EQ

[esteban_760]

Hey all,

"My friend" has bought gear from a reliable UG source in the past. While getting stocked up for his next cycle, he has continuted to purchase gear from that same source. The latest purchase was a bottle of 300mg EQ(Bold-Undec) about a month ago.

He can't remember if he inspected the oil up to the light at the time of purchase. Well, last night, looking at the bottle up to the light he noticed a very very small almost "donut glaze" thin looking item floating in the bottle. The Test-E and Deca-D bottles were then inspected but contained no floating materials.

The source was asked today and got a response that if the bottle had been stored in cold temperatures for awhile, (which it had) then that material was from the bonding due to cold temperature.

My friend is not sure he buys that but does know that every other item purchased within the past 6 months has never had a problem and to his knowledge, the UG is completely sterile.

So the question is: Has anyone ever had this occur before? Should he toss the gear and purchase new EQ? If the last statement holds true, should the rest of the gear be tossed - or what that be too extreme?

Thanks!

[turbodiesel]

The EQ hardly ever falls out of solution. It is usually in a liquid state unless it is very cold. So the fact still remains that you need to see if the "stuff" in your UG Gear is a Hormone falling out of solution or a future abscess.

I say vent the vial with a small needle and slowly warm the contents in a water bath (water in a pan that gets heated and the vial sits in this water).

If it all goes back to solution you should be good, but don't just assume. Filter the contents thru a .20 Millipore syringe filter into a sealed sterile vial. Now you should be ready to use it up.

One more thing....Store your gear at room temperature and away from direct light.

Peace,

TurboD.

[DragonRider]

That's good advice.

[esteban_760]

TurboD,

Thank you for the advice! Your suggestion will be used, and the results posted.

Let's say that the foreign material does NOT (for lack of a better term) "dissolve" back into the solution. Should the gear then be tossed?

[The Anonymizer]

What lab was the bottle from?

If it was from Hardcore Pharms or GA Labs the white stuff is probably semen. The lab owners like to add that in their oils for extra viscosity....and because they're homos.

Just refilter and you'll be fine.

[esteban_760]

Originally Posted by The Anonymizer

What lab was the bottle from?

If it was from Hardcore Pharms or GA Labs the white stuff is probably semen. The lab owners like to add that in their oils for extra viscosity....and because they're homos.

Just refilter and you'll be fine.

HA! Well, semen never hurt anyone - just ask all the whores that went to my highschool.

No name for the lab. He only makes limited batches for certain people. Good quality stuff though!

[turbodiesel]

Whatever it is the syringe filter should get it. The only way I can see that it would not get it is if the white stuff is water or moisture. The water bath should get the water to evaporate. If the white stuff is gone and then reapears, then you have moisture and will need to add some Benzyl Alcohol to the product to absorb the moisture. Let us all hear what happens.

[The Anonymizer]

could also be a small amount of unesterfied hormone....because as you know if you add a drop of test suspension to a bottle of oilbased test the white substance just floats around.